5/2/2023 0 Comments Raspberry pi repetier server![]() If you had a license key, go to the Register page and activate your license key.Open Repetier-Server in your browser and go to Global Settings WLAN and make sure that Hostname, SSID and Region in Connection Settings are set like before.Do not forget to save your password on a place, where you’ll find it later. Enter in ssh console:Īnd change your password. In my case I use Repetier Server to manage my printers and it makes the setup even easier. The pi is just recommended because it's small and fits nicely under the printer and has all the support and features you need. Make your Pi more secure by using your own password. The commands would be same for a pi or a computer, and the hookup is the same with a USB cable. ![]() Go to Localisation Options Change Timezone, select your country and finish. Set the correct time zone in ssh console:.Copy them to /var/lib/Repetier-Server with a secure copy software like WinSCP or scp. Now it’s time to restore your backup files.Sudo chown -R pi /var/lib/Repetier-Server Now you need to change the permissions of /var/lib/Repetier-Server, so you can overwrite the files:.Start the Pi and connect it to the network.Download the new Raspberry Pi image here and install it as described on your sd card.Now we have all relevant data on a different computer, so we can shut down the pi in ssh console:.But with the old files it should be much easier to restore the old state. New image might have new settings in the files. Download: Flash the image There are several ways to do this, but the easiest might be to use the tool Etcher for this job. Typical things you might have done are modifying /boot/config.txt, /boot/cmdline.txt, adding own scripts, installing additional display drivers, … Note that you can not always just blindly copy old configs back. Prepare your Raspberry Pi First of all you need to download the disk image for the Raspberry Pi from the Repetier Server homepage. If you made other changes to linux to get the image working also backup these files.The simplest solution to backup all files and folders in this directory is using a secure copy software like WinSCP or scp on your target PC, where you want to store the backup. These are stored in the directory /var/lib/Repetier-Server and it’s subdirectories. Now it’s time to backup all settings and data.The default user is pi and the default password is raspberry. you succesfully installed Repetier server to your Raspberry Pi. Go to Global Settings WLAN and note your Hostname, SSID and Region in Connection Settings.If you have a license, write down your license key and deactivate it on the Register page.If you have two sd cards, we recommand to create the new image on the second sd card (ideally a high endurance sd card for increased data safety) so you know you have a working fallback. So we will describe here in detail how to transfer your old settings to the new image. Of course you will want to keep your old settings and data. We regularly revise our Raspberry Pi image and add new features, so it makes sense to upgrade, especially if the operating system version has changed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |